Thermaltake LANBOX Mod

I finished the sides of my case.

I went to the hardware store and picked up some mounting hardware to hold the metal in place. I mounted the pieces on the inside of the case.

Here's pictures!

Installed on the inside of the case. Mounted by the plastic pins that held in the clear plastic side panels. And the one screw mentioned below.



I first tried with this screw. It looked decent. But I only had one so I had to go to the hardware store for some more.



The other side.


The hardware store did not have exactly what I had already. Thats ok though. I was able to find something similar. I am rather pleased with the results too.

3/8 long screw, rubber washer, case, rubber washer, aluminum, flat round nut with threads. Here's the outside.

Inside



Left Side





Right Side

Nice job

Thanks.

I flipped the power supply back over so it is pulling air from the outside of the case. I then installed a 60 mm x 10 MM fan where a 60 mm x 25 mm fan was. I was only able to get one in though. I'll have to remove the CPU cooler to install the other one. But there should be enough room.

I tested it out the LAN this weekend. My case stayed pretty cool. Everything stayed right around 40 C.